Blade Bevel Control; Extending Table Extension; Using Rip Fence Pointer; Using Table Pointer - skilsaw SPT70WT Instrucciones De Funcionamiento Y Seguridad

2610039875 12-15 E_SPT70WT 12/23/15 10:55 PM Page 26

BLADE BEVEL CONTROL

Loosen blade bevel lock handle counterclockwise
(Fig. 41), slide the elevation wheel until pointer is
at desired angle and tighten blade tilt lock handle
clockwise.
FIG. 41
Table Extension Lock
USING THE RIP FENCE POINTER
WHEN TABLE IS NOT EXTENDED
The rip fence pointer shows the distance from the
blade to rip fence.
Align rip fence pointer with lower portion of scale.
The lower scale can be used for widths up to 11
inches (Fig. 43).
USING THE TABLE POINTER
WHEN TABLE IS EXTENDED
The upper portion of scale is used for rip cut 11 to
25 inches. Align table pointer with upper portion of
scale (Fig. 43).
FIG. 43
Upper
Scale
Lower
Scale
Elevation Wheel
Lock Handle
Table
Pointer

EXTENDING TABLE EXTENSION

To extend the table, raise the table extension lock
handle (Fig. 41) and slide table extension to de-
sired width (Fig 42). To secure table setting, lower
the lock handle.
FIG. 42
NOTE: As noted on the scale, the maximum cut-
ting capacity to the right of the blade when the ex-
tension table is closed is 11". The maximum
cutting capacity to the right of the blade when the
extension table is fully extended is 25". To achieve
these capacities, a portion of the fence glide pads,
located underneath the locking lever, will hang off
the rail. The rip fence pointer should never be
positioned beyond 11" on the lower scale.
Rip Fence
Pointer
-26-
Table
Extension
Edge of
table
Glide Pad