Adjustable Or Wobble Dado Sets - skilsaw SPT70WT Instrucciones De Funcionamiento Y Seguridad

2610039875 12-15 E_SPT70WT 12/23/15 10:55 PM Page 35
To reduce the risk of injury,
never use a single dado blade
WARNING
for normal saw through sawing. Never use
chippers without both outside cutters. Read
and follow all Operation/Safety Instructions in-
cluded with the dado set.
NOTE: With this saw, do not exceed a stacked
width greater than 1/2". Use combination
nut/washer supplied with the SPTA70WT-DD.
7. Lower the blades below the table top and insert
the Skilsaw Dado Table Insert (SPTA70WT-DD)
(Fig. 63). Raise the cutters to the desired depth
of cut (above the insert). Check that the tool is
not plugged into a power source; then carefully
rotate the cutters by hand to make sure all com-
ponents are tightly held and no interferences
exist.
8. Plug saw into power source. Using scrap wood,
make practice dado cuts and adjust height ac-
cordingly.
To reduce the risk of injury,
never pass your hands over
WARNING
the cutting dado blades. Dado cuts are non-
through (blind) cuts. Many times the cutters cannot
be seen during cutting. See page 33 for instruc-
tions on Non Through Sawing.
To reduce the risk of injury,
never make freehand cuts. The
WARNING
work piece must be held against the saw's fence
or miter gauge as it is being fed. Whenever possi-
ble, use push sticks and push blocks for cutting
(see page 32). Always use feather boards, at-
tached to the table or fence, when rip cutting (See
page 33). When cross cutting, firmly hold work
piece against the miter gauge (see page 29).
NOTE: Because dado cuts are non-through cuts,
the miter gauge can be used with the fence locked
in place. This is helpful when making repeat dado
cross-cuts from the ends of more than one work
piece. Each piece is held against the miter gauge
and its end slides along the fence at a preset dis-
tance.
Depending on the final depth of cut and/or the
density of the material, it may be required to make
multiple cuts starting with small depths of 1/4" to
1/2" and progressing to final depth. When perform-
ing extensive repetitive dado cutting, periodically
check the work pieces to see that the depth of cut
is maintained.
RETURNING SAW TO NORMAL
THROUGH SAWING
After completing your Dado cutting, be sure to re-
turn the inner and outer washers to the original po-
sitions (see page 16 for details). It is important that
the original equipment washers are in the proper
positions so that the saw blade always aligns with
the permanently installed riving knife.
ADJUSTABLE OR WOBBLE
DADO SETS
To reduce the risk of injury, do
not use adjustable or "wob-
ble" dado sets on this saw. Adjustable dado sets WARNING
can be easily set to positions that may interfere
with working components of this saw.
FIG. 63
Dado Table
Insert
-35-
FIG. 62
Use Accessory
Combination
Nut/Washer