Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. A tube fuse is installed the red wire (Power) and 12V/15A tube fuse is installed in yellow wire (Battery).
Therefore, replace tube fuses according to the requirements.
Explanation for Installation
Please refer to Installation Drawing.
Power Supply and Polarity:
The anode should be connected with the anode of car battery and the cathode should be earthed (the cathode
of battery or body frame).
Note: To avoid any short, please connect the cathode of battery after finishing installation.
The Installation of Metallic Sheath
• Install metallic sheathes on the instrument panel (see Installation Drawing I).
• Fasten a metallic sheath on the instrument panel and remove the card on the metallic sheath with a driver to
fasten the metallic sheath.
The Connection of Power Supply
16
• Red (ACC wire): Connect it with the anode in 12V constant voltage (it is controlled by ignition device of the
car);
• Yellow (Power cable): Connect it with the 12V power switch (the power is for the player's memory).
The Connection of Loudspeaker
• The device can be adopted the loudspeaker with load impedance of 4-8. Before connecting a loudspeaker,
please cut off the power to avoid any short.;
• Note: Do not contact the loudspeaker cable with the car's ground wire; especially, avoid any contact between
the loudspeaker cable and power cable; otherwise, the loudspeaker will be damaged seriously.
The Installation of Host Machine
• Insert the aerial plug into the antenna pedestal (adjust the antenna for a good effect);
• Push the machine into the metallic sheath until it is locked (see Drawing II).
Disassembly:
• Remove the panel's frames and then insert two brackets into the hole until they are locked; then pull the
machine out (See Drawing III, IV and V).
Replacement of Fuse
Pull out the invalid fuse and insert a new fuse with the same specification into the blank socket.
www.multilaser.com.br
Publicidad
Tabla de contenido
