Outdoor Unit - ITS EKSELANS KVP 1430 Manual De Usuario

EN
• Indoor monitor configuration as master
The monitor contained in the KIT is configured as master.
Monitors purchased as an individual reference (MON 43 or
MON 70) outside the kit are configured as slaves.
After making the connections and connecting the power su-
pply to the network, press the
4 tones will be heard. Then press the call button on the out-
door panel. The monitor will hear a tone and an image will
be displayed. Press the
4 tones will be heard. The monitor is now set to master.
• Indoor monitor configuration as slave
After making the connections and connecting the power supply
to the network, press the
be heard on the monitor. Press the call button on the outer pla-
te. The monitor will hear a tone but no image will be displayed.
Press
this moment, the monitor is configured as a slave.
Verification of coded equipment:
Outdoor panel.
To identify whether the outdoor plate is configured as master or sla-
ve, press the monitoring button
outer board will be displayed.
To identify whether the outdoor panel is configured as a slave, press
the monitoring button
configured as slave.
Indoor monitor.
When the whole system is configured correctly there is no distinction
between master or slave monitor. However, if only one monitor is left
connected, we can find out its configuration in the following way:
Press the button bell button. If picture and audio are displayed, this
monitor is set to master. If, on the other hand, only audio is heard, the
monitor is configured as a slave.
5. SYSTEM ADJUSTMENTS
Once done the first installation make the following adjustments:

5.1. Outdoor unit

Adjust again the camera angle of the outdoor unit in order to
take best frame possible of the image at the street.
Adjust the volume level of the outdoor unit with the potentiometer at
the front side.
94
button again for 3 seconds and
button for 3 seconds. 4 tones will
for 3 seconds again and 4 tones will be heard. From
once. The image of the master
until it shows the image of the street panel
button for 3 seconds and