Operation On/Off Operation; On/Off Operation; Earth Resistance - KPS TLP100 Manual De Instrucciones

Earth Resistance Clamp Meter
1． Buzzer ON symbol
2． HOLD symbol : hold the last measurement
3． Interference Symbol : showing that the current in
the loop is disturbed such that the resistance
measurement value is not be guaranteed.
4． Clamp symbol : showing that the clamp is closed
incorrectly, can not measure.
5． Wait symbol : showing that the instrument is
auto-calibrating
6． Current measurement unit
7． Resistance measurement unit
8． Decimal points
9． Percent sign of the batteries actual service life
10. Alarm threshold value of resistance unit
11. Digital display of the battery actual service life or
Alarm threshold value
33
05
Earth Resistance Clamp Meter
12. High Alarm symbol
13. Low Alarm symbol
14. Alarm mode symbol
15. Low voltage indication symbol
16. Auto Power Off symbol
17. Record number symbol
18. Read memory mode symbol
19. save in memory mode symbol
20. 4 digit LCD digital display
Operation

1.ON/OFF Operation

button switches ON/OFF. Press
clamp switch on, Press the
the instrument switch off.
As soon as it switch on, the earth resistance clamp
begins to auto-calibrate to obtain batter resolution.
When it is calibrating, the instrument will count from
CAL 9 to CAL 0. The user must wait for the clamp
completed calibration. Do not open the clamp or hook
the clamp jaw around the conductor or the object be
measured in case of the calibration. After the calibration
completed, the instrument returns the measurement
mode when last switch off. If the instrument is in
resistance measurement mode when switch off, the
LCD will display the primary resistance measured value.
button so the
button for 2 seconds,
34
06