Vimar RS02 Manual De Instrucciones Para La Conexión Y El Uso página 37

RS02
- the gate/barrier opens and closes completely and the display shows 4 dots (reading the current thresholds)
- when completely closed, the display shows END,indicating that the travel has been saved correctly.
8.4 PAR:
Used to modify all the parameters of the control unit, press the UP button until PAR appears on the display, confirm with the OK button to dis-
play the list of parameters, the display will show P 01 (parameter number 1), the UP or DOWN button lets you scroll through the list of parameters (see
parameter table).
x4
Parameter table
Number
of parameter Description
P01 Enables automatic closing
P02 Sets the automatic closing time
P03 AP/CH input operation
P04 Pre-flash
P05 Closing after photocell disengage-
ment
P06 Type of safety device connected to
the STPA input
P07 AUX output operating mode
P08 Enables photocell control
P09 Slowdown distance when closing
P10 Slowdown distance when opening
P11 Opening speed
P12 Closing speed
P13 Opening deceleration speed
P14 Closing deceleration speed
P15 Motor force
P16 Intensity of stopping with opening
limit switch tripping
P17 Intensity of stopping with closing
limit switch tripping
P18 Separate buttons
Settable values
ON/OFF
2-600 seconds
1= when opening, AP/CH input not active (condo)
2=AP/CH as sequential (open, stop, close, stop..)
3=AP/CH as sequential (open, open, close..)
ON/OFF
ON/OFF
1= photocell as protection on opening
(if engaged it stops the gate/barrier, until it is disengaged, and then it
continues in the same direction)
2= microswitch sensitive edge
3= resistive sensitive edge (balanced with resistance (8.2Kohm)
4= photocell as internal protection (if engaged it stops the gate/barrier,
until it is disengaged, then it continues opening)
1= disabled
2= flashes while the gate/barrier is moving
3= flashes while the gate/barrier is moving and stays on steady when
the gate/barrier is stationary
0= Control disabled, 1= Control on FOTO input
2= Control on STPA input, 3= Control on STPA and FOTO inputs
0-150cm
0-150cm
50-100%
50-100%
20-75% - Minimum speed 20%
20-75% - Minimum speed 20%
Min. 1-10 max
0-10
0= instantaneous stop
10= soft stop
0-10
0= instantaneous stop
10= soft stop
0= AP/CH controls complete opening and closing of the gate/barrier,
P
ED controls partial opening and closing of the gate/barrier
1= input AP/CH, controls opening only and input
PED, controls closing only
2= input AP/CH and the button of the remote control saved as CH1
controls opening only and the PED input and the button of the remote
control saved as CH2 controls closing only
EN
Press the button until you
see the parameter to be
modified
Default Modified
value value
ON
60 seconds
1
ON
OFF
1
2
0
73cm
49 cm
100%
100%
50%
50%
5
5
5
0
35