ESAB PCC-14 Manual De Instrucciones página 26

SEcTIoN 2
ON
OFF
2 .
chassis ground
3 . Thread the five service lines of the PT-26 torch through bushing at upper left corner of the front panel and connect them
to the matching fittings on output terminal . Hose connections should be wrench-tight . Make sure plug of the switch
lead is firmly locked in place . Then close hinged cover .
If a PT-26 In-line torch is being used in a mechanized installation where only an
5
arc start signal is required, connect the optional Remote Hand Switch, ESAB part
number 2075600, to the Torch Switch Receptacle on the hook-up panel in the
Connect cable
nized version of the PT-26 plasma torch .
Connect lines from plumbing box to the power source . Open top front cover to gain access to the
torch connections .
2
2
4
4
5
2
Water IN (+)
(Pilot arc)
Interconnection Diagram - Front of ESP-150
DEScRIPTIoN / INSTallaTIoN
Note:
front of the ESP-150 console .
5
, in place of item 5 from the torch bundle, to adapt the mecha-
Pilot arc adapter
(P/N 0558009992)
Power/Coolant adapter
(P/N 36743)
(Manual torch only)
4
Water oUT (-)
(Electrode)
26
5
Torch Switch
Receptacle