Safety Precautions - ESAB PCC-14 Manual De Instrucciones

SEcTIoN 1
1.0 Safety Precautions
Users of ESAB welding and plasma cutting equipment have the ultimate responsibility for ensuring that
anyone who works on or near the equipment observes all the relevant safety precautions . Safety precautions
must meet the requirements that apply to this type of welding or plasma cutting equipment . The following
recommendations should be observed in addition to the standard regulations that apply to the workplace .
All work must be carried out by trained personnel well acquainted with the operation of the welding or plasma
cutting equipment . Incorrect operation of the equipment may lead to hazardous situations which can result in
injury to the operator and damage to the equipment .
1 . Anyone who uses welding or plasma cutting equipment must be familiar with:
- its operation
- location of emergency stops
- its function
- relevant safety precautions
- welding and / or plasma cutting
2 . The operator must ensure that:
- no unauthorized person stationed within the working area of the equipment when it is started up .
- no one is unprotected when the arc is struck .
3 . The workplace must:
- be suitable for the purpose
- be free from drafts
4 . Personal safety equipment:
- Always wear recommended personal safety equipment, such as safety glasses, flame proof
clothing, safety gloves .
- Do not wear loose fitting items, such as scarves, bracelets, rings, etc ., which could become
trapped or cause burns .
5 . General precautions:
- Make sure the return cable is connected securely .
- Work on high voltage equipment may only be carried out by a qualified electrician .
- Appropriate fire extinquishing equipment must be clearly marked and close at hand .
- Lubrication and maintenance must not be carried out on the equipment during operation .
Enclosure Class
The IP code indicates the enclosure class, i .e . the degree of protection against penetration by solid objects or
water . Protection is provided against touch with a finger, penetration of solid objects greater than 12mm and
against spraying water up to 60 degrees from vertical . Equipment marked IP23S may be stored, but is not in-
tended to be used outside during precipitation unless sheltered .
caUTIoN
If equipment is placed on a surface that
slopes more than 15°, toppling over may oc-
cur. Personal injury and / or significant dam-
age to equipment is possible.
SaFETY PREcaUTIoNS
Maximum
Tilt Allowed
15°
9