Automatic Start Brewing Coffee; Pause And Serve; Auto Shut Off; Brewing A Second Carafe Of Coffee - Bella 14391 Manual De Instrucciones

Gourmet strength coffee
The gourmet setting adjusts the brewing cycle of a full pot of coffee to extract a higher percent of solubles.
This results in a more flavorful pot of coffee.
Bold strength coffee
The Bold setting adjusts the brewing cycle of a full pot of coffee, allowing more time for the coffee to "steep"
to extract further oils and flavor from the coffee bean. This results in a bolder tasting pot of coffee
1-4 cup brew cycle
Automatically adjusts the brewing process for maximum flavor when brewing small quantities.
Ideal for brewing 1 to 4 cups of coffee.
* If 12 cups of water are poured into the water tank then 12 cups of coffee will brew.

Automatic start brewing coffee

Press and hold the AUTO button until PROGRAM appears and starts flashing along with the clock. Follow the
clock setting method to set hour and minute, then press AUTO or SEL button to set the machine. The unit
will beep and display the current time. The LCD will also display the TIMER icon, which confirms the unit will
brew automatically at the set time. Once the current time reaches the set time for the auto brew, the unit will
start the brewing cycle.

Pause and Serve

Using the pause and serve feature: If you wish to serve a cup of coffee before the brew cycle is completed, simply
remove carafe from the warming plate. Dripping will automatically cease. Return the carafe onto the warming
plate; dripping will resume.
CAUTION: To prevent injury when utilizing pause and serve feature, replace carafe within 30 seconds after
removing during the brewing process.
1. After approximately 2 cups of coffee have been brewed, the carafe may be slowly removed and the coffee
will stop dripping.
2. The flow valve is located on the bottom of the filter holder and is activated when the carafe is removed.
(See Figure 1.) This design makes it possible for you to remove the carafe and pour a cup of coffee before
the entire carafe is brewed.
IMPORTANT: When replacing the filter holder, the flow valve must be properly inserted into the front hole
of the machine, so that it can be seen as it sits on the top of the carafe lid. (See Figure 1.)
3. When using this feature, make sure that the carafe is replaced under the filter holder within 30 seconds
to prevent overflow.

Auto shut off

2 hours after the brewing cycle has stopped the unit will automatically turn the heating element off.

Brewing a Second Carafe of Coffee

1. To brew another carafe of coffee, press the START or
plug from wall outlet. It is recommended that the Coffee Maker be off and allowed to cool for 15 minutes
between cycles.
CAUTION: Failure to allow Coffee Maker to cool sufficiently could cause hot steam and spray when
the water is added to the water reservoir. The hot steam can cause severe burns.
2. Lift the Coffee Maker lid. Unfold the handle, lift and remove the permanent coffee filter; discard used
coffee grounds, rinse.
3. Lift the removable filter holder up and out of the Coffee Maker.
4. Rinse the glass carafe and removable filter holder in cool, clean water.
IMPORTANT: Before brewing a second carafe, always check to make sure water level is past the MIN line;
add the desired amount of cold tap water into the water reservoir.
5. Place empty carafe on the warming plate.
6. Place the permanent filter in the removable filter holder. Measure 1 level tablespoon of drip or regular
grind coffee for each cup of coffee desired.
7. Place the filter holder down into the housing. Close the lid.
8. Plug Coffee Maker into a 120V AC electrical wall outlet.
9. Press the START or
Depending on the Country the unit was purchased, U.S. or Canada, please refer to "Control Panel" on page 5.
*
SO-311280 Bella IM Linea 12cup Programmable Coffee maker_IM_r8.indd 7
button . Brewing will begin.
*
button to turn the Coffee Maker off. Remove
*
7
2014-07-11 1:29 PM