Use Instruction; Turn On The Autoclave - Tecno-gaz alia B Instrucciones De Uso

8
8.1

Turn on the autoclave

Press the main switch
the memory and the connections. The result of the checks is shown on the display
(FIG.22).
Once checks are over the autoclave shifts to the operating setup (FIG.23).
Open the door and wait for some seconds until an acoustic signal informs that the
automatic barometric alignment values have been acquired; at the same time the display
shows the message
IMPORTANT:
Never select an item before the acoustic signal, the autoclave will not accept the
preset selection.
USE INSTRUCTIONS
B-MAIN (FIG.2). After the display of the logo, the autoclave checks
. The autoclave is ready for use.
DOOR OPEN
FIG.22
FIG.23
ENGLISH
21