ECOVACS ROBOTICS WINBOT 950 Manual De Instrucciones página 5

16. When charging the Appliance, do not place it on other
electrical appliances and keep it away from fire and liquid.
17. Take care not to damage the power cord. Do not pull on or
carry the Appliance by the power cord, use the power cord as a
handle, close a window on the power cord, or put heavy weights
on the power cord. Keep power cord away from hot surfaces.
18. Do not use with a damaged power cord or receptacle. Do not
use the Appliance if it is not working properly, has been dropped,
damaged, or come in contact with water. It must be repaired by
the manufacturer or its service agent in order to avoid a hazard.
19. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent in order to avoid a hazard.
20. The plug must be removed from the receptacle before cleaning
or maintaining the Appliance. Do not unplug the Power Adapter
by pulling on the power cord.
21. The Back-Up Battery must be replaced by the manufacturer or
its service agent in order to avoid a hazard.
22. The Back-Up Battery must be removed and discarded according
to local laws and regulations before disposal of the Appliance.
23. The Appliance must be disconnected from the receptacle
before removing the battery for disposal of the Appliance.
24. Please dispose of used batteries according to local laws and regulations.
25. Do not incinerate the Appliance even if it is severely damaged.
The battery can explode in a fire.
26. The Appliance must be used in accordance with the directions
in this Instruction Manual. The company cannot be held liable or
responsible for any damages or injuries caused by improper use.
27. WARNING:
the detachable supply unit EA10952 provided with this Appliance.
28. The robot contains batteries that are only replaceable by
skilled persons.
29. The Remote Control pre-installs two non-rechargeable AAA R03
batteries. To replace the battery of the Remote Control, please
turn over the Remote Control, press and remove its Battery
Cover. Remove the batteries, and insert the new batteries with the
correct polarity. Reassemble the Battery Cover.
30. Non-rechargeable batteries are not to be recharged.
31. Different types of batteries or new and used batteries are not
to be mixed.
32. Batteries of the Remote Control are to be inserted with the
correct polarity.
1. Important Safety Instructions
For the purposes of recharging the battery, only use
3
EN