Miele professional HM 29-175 Instrucciones De Manejo página 19

Cleaning and care
Switch the machine on, set to the slowest
speed and let the ironing cloth cover run
through as shown in phase 5.
Fitting the ironing cloth cover on a roller
with leaf-type padding
The ironing cover should be wound back on
when still damp.
A double layer is wound on to the roller in one
operation. Do not tuck in the cloth at the ends
of the roller.
Place the cloth in position. Ensure that the
hand wheel is turned as far as it will go in
an anti-clockwise direction, so that the
heater plate is lowered and cannot rise up
again. Switch the machine on and feed it in
following the laundry feed direction using a
low roller speed setting until it lies smooth
and flat. This is to ensure that the heater
plate does not get damaged by the grip-
pers on the leaf-type padding.
Switch the machine off and turn the hand
wheel in a clockwise direction about 4
times to raise the heater plate.
Switch the machine on and the heater
plate will raise up completely. Let the roller
rotate slowly. The ironing cloth cover must
have no creases in it. Let the roller rotate
for about 5 minutes.
Discoloration of the ironer cloth
Some discoloration of the ironer cloth from
light to dark brown is normal.
Cloth leading
To avoid the cloth turning black:
edge
- always use the complete width of the roller.
- space out smaller items and do not always
Phase 5
place them in the same place.
- in pauses between ironing, withdraw the
heater plate or trough and reduce the
temperature.
19 M.-Nr. 05372840