Soler & Palau ADVANZ Instrucciones De Uso página 41

The corresponding day is displayed in the top left corner of the screen, while the summary graphic of the
timetable is displayed in the bottom part; the other lines of the screen are as follows:
Change 1: when this line is selected, the time range that is being modified (1→8) can be changed
without having to return to the previous page.
Time 00.00: the starting time of the current time range is set; this parameter may take a value not smaller
than the beginning of the previous time range and not greater than the following time range (with 30-
minute intervals).
Fan speed low: the fan speed may take low, medium and high values.
Post-heating on: if the unit is fit with a post-heating system, post-heating can be switched on (on) or not
(off).
In order to return to the screen with the time ranges, run the change window procedure; now, either set
another time range or return to the Time table (change window procedure). Otherwise, set another day or
return to the Program menu (change window procedure).
The timetable of another day can be set by restarting from the relevant point or copying the timetable of
another day: for example, in order to copy the Tuesday timetable to Wednesday, select Wednesday (press
the knob) and scroll the time ranges (turn the knob counterclockwise) until the Copy day function is
highlighted, then press the knob.
Select the day you want to copy from the list of the days of the week (Tuesday) and press the knob. Return
to the relevant screen and verify data have been copied properly.