Connecting Cartridges To The Mains Water Supply And The Washer-Disinfector; Venting The Cartridges; Inserting A Cartridge; Removing A Cartridge - Miele professional UG 70-60/80 Instrucciones De Manejo

en - Water demineralisation
Venting the car-
tridges
Inserting a car-
tridge
44
Connecting cartridges to the mains water supply and
the washer-disinfector
Guide the hoses through the openings provided on the back panel

of the UG 70-60/80 unit.
Ensure that the hoses are not kinked when doing this.

Connect the "H2O pur" (green) hose to the solenoid valve for AD

water or to the AD water inlet hose for the washer-disinfector.
Connect the "Inlet (Eingang)" (red) hose to the on-site cold water

mains supply stopcock.
Important
Water pressure (flow pressure) must be between 250 - 1000 kPa
pressure (2.5 - 10 bar).
The water temperature must not exceed 20 °C.
Open the valve by turning it anti-clockwise.

Open the cold water stopcock until water escapes from the valve.

Then close the valve.

The demineralisation cartridge is now ready for use.
Place the connected cartridges into the back of the UG 70-60/80

unit.
The front area can be used to accommodate a spare cartridge.

Removing a cartridge

Close the cold water stopcock.

Open the stopcock for drawing manual AD water (if available), or:

Open the valve on the cartridge to release any pressure.

While doing this, water can escape which should be wiped up
with a cloth.
Unscrew the hoses.

Upend the cartridge to drain the residual water into a suitable out-

let.

LP 2800 empty cartridge

The LP 2800 cartridge is supplied unfilled and must be filled on site
with 19 l of single use resin prior to use (see "Filling an empty LP
2800 cartridge with single use resin").
When depleted replace the spent resin with new single use resin.