Installation - ESAB PowerCut 700 PT-39 Manual De Instrucciones

US
5

INSTALLATION

The installation must be done by a professional.
Correct installation is very important for trouble-free operation and good cutting
results. Carefully read and follow each step in this chapter.
ELECTRIC SHOCKS CAN KILL. TAKE PRECAUTIONARY MEASURES AGAINST
ELECTRIC SHOCKS. ENSURE THAT ALL POWER SUPPLIES ARE DISCONNECTED
–
SWITCH OFF THE SWITCH AT THE WALL SOCKET AND PULL OUT THE
EQUIPMENT'S POWER CABLE FROM THE SOCKET BEFORE MAKING ANY
ELECTRICAL CONNECTIONS IN THE POWER SOURCE.
IT IS VERY IMPORTANT THAT THE CHASSIS IS CONNECTED TO THE APPROVED
ELECTRIC PROTECTIVE EARTH, TO PREVENT ELECTRIC SHOCKS AND
ELECTRICAL ACCIDENTS. ENSURE THAT PROTECTIVE EARTH IS NOT
CONNECTED TO ANY PHASE CONDUCTORS BY MISTAKE.
POOR CONNECTIONS OR FAILURE TO CONNECT THE RETURN CABLE TO THE
WORKPIECE CAN RESULT IN FATAL ELECTRIC SHOCK.
AIR FILTER DEVICES MAY NOT BE USED
FORM OF AIR FILTER DEVICE PREVENTS THE COLD AIR FLOW AND CAUSES A
RISK OF OVERHEATING. THE WARRANTY IS INVALIDATED IF ANY TYPE OF AIR
FILTER IS USED.
DO NOT START THE EQUIPMENT WITH THE COVER REMOVED.
DO NOT CONNECT THE EQUIPMENT UNDER TENSION OR WHEN YOU ARE
HOLDING IT OR CARRYING IT.
DO NOT TOUCH ANY OF THE TORCH'S PARTS WHEN THE POWER SUPPLY IS ON.
This product is intended for industrial use. In a domestic environment this product
may cause radio interference. It is the user's responsibility to take adequate
precautions.
bp23aa
–
INSTALLATION OR MOUNTING OF ANY
- 10 -
© ESAB AB 2012