OPERATING INSTRUCTIONS
TO ACCESS CONTROL PANEL
Control panel can be accessed at upper right-hand corner of insert by pushing and lifting up the
small door.
TO ACCESS CONSUMER INFORMATION
Consumer service information can be accessed at the upper left-handed corner of the electrical fi replace
by pushing and lifting the small door.
POWER
The power switch supplies power to all of the functions of the fi replace.
HEATER
Your fi replace consists of a fan-forced wire-element-type heater. The heater switch turns the heater
ON and OFF. The temperature switch controls the thermostat feature to help regulate the room's
temperature accordingly. As an important safety feature, the heating element is designed with a
delayed activation sequence. When the heater is turned ON it will take several seconds for the unit
to begin blowing hot air and the fan blower will continue to run for several seconds after the heater is
switched OFF.
TEMPERATURE
The temperature control knob regulates the temperature level of the heater. Turning the knob
clockwise will increase the heat output. The further the knob is rotated clockwise, the higher the
set point temperature. Turning the knob counterclockwise will lower the set point temperature.
Use this function to help regulate the ambient temperature level.
BRIGHTNESS
The fl ame brightness control knob adjusts the fl ame brightness. Turning the knob to the left
(counterclockwise) dims the lights and fl ame effect. Turning the knob to the right brightens the lights
and fl ame effect.
Consumer
Information
10
Fig. 1