Care And Maintenance; Clearance To Combustibles; Replacing The Light Bulbs - Twinstar Home 73696/18SM9977-PC76 Manual De Instrucciones

CARE AND MAINTENANCE

CLEARANCE TO COMBUSTIBLES

Keep electrical cords, drapery, furniture and other combustibles at least 3 ft. from the front of the heater
and away from the sides.
CLEANING TRIM
Clean the metal trim using a soft cloth, slightly dampened with a citrus oil-based product and buff with a
clean soft cloth. Do not use brass polish or household cleaners as these products will damage the metal
trim. Citrus oil-based products can be obtained at supermarkets or hardware stores.

REPLACING THE LIGHT BULBS

This electric fi replace uses two clear 120-volt, 40-watt, E12 candelabra-base light bulbs.
The insert 18EF010GAA only require two clear 120-volt, 40-watt candelabra-base light bulbs. For
convenience, if a bulb burns out, it is a good idea to replace all the bulbs at the same time.
1. Turn the master power switch off, then unplug
the power cord from the wall outlet.
2. If fi replace has been operating, let the unit cool
at least 2 hours.
3. Locate and rotate the 2 nuts on the glass holder in
counterclockwise direction to loosen the glass from
insert. (Fig. 1).
4. Carefully tilt glass and frame forward a couple of
inches. Then pull complete glass assembly up and
away from unit (Fig. 2).
5. Locate the two ember bed securing nuts on the left
and right sides of the log set. These securing nuts
are disguised as wooden embers (Fig. 3).
2
Wooden Ember Nuts
11
2 Nuts
Fig. 1
2
Fig. 2
Fig. 3