Preparation; Assembly Instruction - Twinstar Home 73696/18SM9977-PC76 Manual De Instrucciones

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts
with package contents list and diagram above. If any part is missing or damaged, do not
attempt to assemble, install or operate the product. Contact customer service for
replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors
and utility knife
ASSEMBLY INSTRUCTIONS
Camlock installation.
For correct installation, screw AA-1 must be
inserted and tightened in the pre-drilled hole.
Camlock AA-2 must be inserted into the
pre-drilled hole with the cross positioned in
the direction of screw AA-1.
1. Locate the Left Front Panel (B), Right Front Panel
(C), Center Front Panel (D) and set out face down
on a scratch-free surface.
Insert one Wood Dowel (CC) and screw Camlock
(AA-1) into the holes of the left and right front
panels. make sure to tighten Camlock (AA-1).
Push Left Front Panel (B) and Right Front Panel (C)
snug to the Center Front Panel (D). Insert Camlock
(AA-2) into the holes of the Center Front Panel (D).
Insert one Screw (FF) into the pre-drilled holes on
the Center Front Panel (D). Use Phillips head
screwdriver to tighten Camlock (AA-2) and Screw
(FF).
Connect the Left Front Panel (B), Right Front Panel
(C) and Center Front Panel (D) with Connection
Plate (GG), tighten Screws (BB) through the
pre-drilled holes.
Hardware Used
AA Camlock
BB Screw
CC Wood Dowel
FF Screw
Connection Plate
GG
(pre-attached)
Fig. 1
CC
AA
C
x 2
x 2
x 4
x 2
FF
x 2
6
B
D
GG
BB