Specific Safety Rules For Tile Cutters; Features - Urrea CC910 Manual De Usuario Y Garantía

Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
Is recommendable to use a safety device suit-
able, such a thermal and diferential switch
when you are using an electric equipment.
SERVICE
Tool service must be perfomed only by quali-
fied repair personnel. Service or maintenance
performed by unqualified personnel could re-
sult in a risk of injury.
SPECIFIC SAFETY RULES FOR
TILE CUTTERS
IMPORTANT: This manual is intended to fa-
miliarize you with the technical aspects of this
'tile cutter'. It is not, nor was it intended to be,
a training manual. Place the machine on a hori-
zontal, non-skid plane.
• ALWAYS SECURE WORK firmly against the rip
guide or bevel block.
• NEVER stand or have any part of your body
in line with the path of the wheel.
• NEVER attempt to free a stalled wheel with-
out first turning the saw OFF and disconnect-
ing the saw from the power source.
• IF THE POWER SUPPLY CORD IS DAMAGED, it
must be replaced only by the manufacturer or
by an authorized service center to avoid risk.
• AVOID AWKWARD OPERATIONS AND HAND
POSITIONS where a sudden slip could cause
your hand to move into the cutting tool.
• MAKE SURE THE WORK AREA HAS AMPLE
LIGHTING to see the work and that no ob-
structions will interfere with safe operation
BEFORE performing any work using the saw.
• ALWAYS TURN OFF SAW before disconnect-
ing it, to avoid accidental starting when re-
connecting to power supply.
• THIS TOOL should have the following mark-
ings:
a) Wear eye protection.
b) Use splash guard for every operation for
which it can be used.
c) Disconnect saw
changing cutting wheels, and cleaning.
d) Use tool only with smooth edge cutting
wheels free of openings, grooves, and teeth.
18
before servicing, when
e) Replace damaged cutting wheel before op-
erating.
f) Do not fill water bath above water fill line.
WARNING: Some dust created by power
sanding, sawing, grinding, drilling, and other
construction activities
known to cause cancer, birth defects or other
reproductive harm. Some examples of these
chemicals are:
· Lead from lead-based paints;
· Crystalline silica from bricks and cement and
other masonry products;
· Arsenic and chromium from chemically-treat-
ed lumber.
Your risk from these exposures varies,
pending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.

FEATURES

KNOW YOUR TOOL
Before attempting to use this tile cutter, be-
come familiar with all of its operating features
and safety requirements.
WARNING: Do not allow familiarity with
the tile cutter to cause carelessness.
Remember that a fraction of a second of care-
lessness is enough to inflict severe injury.
1. PUMP SOCKET
2. BEVEL LOCK KNOB
3. DEPTH STOP KNOB
4. WATER TRAY FRAME
5. LEG STAND
6. WATER TRAY
7. SLIDING TABLE
8. ON/OFF SWITCH
9. HEAD LOCKIN PIN
10. WHEEL GUARD LOCK
11. TABLE STOP
12. MITER GUIDE
13. SLIDING TABLE LOCK LEVER
14. TABLE STOP BY-PASS
15. DRAINAGE
16. DRAIN PLUG
17. TILE CUTTING WHEEL
contains chemicals
de-