Craftmade WIN56ABZWP5 Guia De Instalacion página 6

5. Fan Assembly. (cont.)
Remove the 2 screws from the edge of the cap
at the top of the motor housing. Align holes in
yoke cover with holes in cap. Re-insert the 2
screws that were just removed to secure yoke
cover. Lower downrod accessory to motor
housing.
With the hanging bracket secured to the
outlet box and able to support the fan, you are
now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod through
opening in hanging bracket and let hanging
ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the
hanging bracket tab.
WARNING: Failure to align slot in hanging ball
with tab in hanging bracket may result in
serious injury or death.
Tip: Seek the help of another person to hold
the stepladder in place and to help lift the fan
up to you once you are set on the ladder.
Find a secure attachment point (wood ceiling
joist highly recommended) and secure safety
cable. It will be necessary to use a heavy duty
wood screw, washer and lock washer (not
supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the
safety cable. The loop at the end of the safety
cable should just fit over the threads on the
wood screw. Extra cable slack can be left in
ceiling area.
yoke cover
wood
ceiling
joist
page 5
screw
motor housing
safety cable loop
wood screw
and washer
safety cable
hanging bracket tab
hanging ball slot
canopy
motor housing