Haverland TAC-0918 Manual De Instrucciones página 58

HEAT MODE(Heating model only)
Press the MODE button a number of times until the HEAT mode light.
Select the target temperature (13-27
value is displayed.
In HEAT mode, the fan speed is selected automatically by the appliance.
Then select the fan speed by pressing the
corresponding to the required fan speed lights up:
HIGH:
the cool operates at maximum to reach the required
temperature as rapidly as possible
MED:
reduces noise levels but still maintains a good level of comfort
LOW: for silent operation
AUTO:
the appliance automatically selects !he most suitable fan speed
in relation to the temperature set on the digital display.
NOTE
At !he beginning of this mode, you may have to wait a few seconds befare the appliance starts to
give out hot air.
In HEAT mode there will be water removed from !he air and collected in !he tank, when !he tank is
full, the appliance shuts down and "
page 11 ) appears on the dispaly, the tank must be emptied , then the appliance will start up again.
When operating in very cold rooms, the appliance defreezes automatically, intermittently
interrupting normal operation. During the defreezing " Lt " (LOW TEMPERATURE as mentioned
in SELF-DIAGNOSIS in page11) appears on the display, at the end of defreezing, it is normal for
the noise made by the appliance when restarting.
When shuts off from this mode, !he fan will continue working for a few seconds to lower !he interior
temperature even after the appliance shuts off.
In this mode, the fan may operate for short peroids even though the set temperature has been
reached.
Operation
°
C) by pressing the + or - button until the corresponding
00
button (C) until the light
Ft " (FULL TANK as mentioned in SELF-DIAGNOSIS in
60