Installation Instructions - Bertolini GIARDINAGGIO Serie Manual De Uso Y Mantenimiento

3.2

Installation instructions.

WARNING!

The pump can be set at work only if the machine in which it is installed
conforms to the safety standards established by the European Directives.
This fact is guaranteed by the CE mark applied and by the Declaration of
Conformity provided by the manufacturer of the machine in which the pump
is installed;

Do not use the pump if it has been subjected to strong impact;

Do not use the pump if there are evident oil leaks;

Take great care when using the pump in places where there are moving vehicles
that could crush or damage the delivery hose and spray gun.

Pump should be installed perfectly lined up with the driven gears (pulleys,
gearboxes, overgears etc.).

Be sure that pump is attached to a strong base plate and anchor it with bolts
sufficiently strong to hold it in place.

Use suction, discharge and by-pass hoses of proper diameter, al least the same
diameter as the pump hose barb or greater. Use spiral steel wire braid reinforced
suction hose to prevent collapse. Use good quality hose clamps and tighten
securely. Use only components (hose, fittings, clamps etc.) Rated for max.
Pressure rating of the pump.

Always remember to fit the safety cone on the transmission shaft so as to prevent
persons from being injured.

Since the pump is the displacement type, it must always be equipped with a
pressure regulating valve.
Failure to follow the above information can result in malfunctions of the pump and
will void the product warranty.
60