Makita M8700 Manual De Instrucciones página 6

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Side grip (auxiliary handle)
2
1
012283
CAUTION:
Always use the side grip to ensure operating safety.
•
Install the side grip so that the protrusions on the grip fit
in between the grooves on the tool barrel. Then tighten
the thumb screw to fix the grip at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 - 1 g).
This chuck lubrication assures smooth action and longer
service life.
Installing or removing the bit
2
1
003150
Clean the bit shank and apply bit grease before installing
the bit.
1
015490
Insert the bit into the tool. Turn the bit and push it in until it
engages.
1. Thumb screw
3
2. Protrusions
3. Grooves
1. Bit shank
2. Bit grease
1. Bit
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
1
012285
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
Depth gauge
2
012286
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the thumb screw and adjust the
depth gauge to the desired depth. After adjusting, tighten
the thumb screw firmly.
NOTE:
The depth gauge cannot be used at the position
•
where the depth gauge strikes against the gear
housing/motor housing.
OPERATION
Always use the side grip (auxiliary handle) and firmly hold the
tool by both side grip and switch handle during operations.
Hammer drilling operation
015491
Set the action mode changing knob to the
Position the bit at the desired location for the hole, then
pull the switch trigger. Do not force the tool. Light
pressure gives best results. Keep the tool in position and
prevent it from slipping away from the hole.
6
1. Bit
2. Chuck cover
2
1. Thumb screw
1
2. Depth gauge
symbol.