Getting Readyto Sew; Connecting Machine To Power Supply; Foryour Safety; When Finished Sewing - Singer 384.18024000 Manual De Instrucciones

GETTING READY TO SEW
Connecting Machine to Power Supply
Power supply plug {_) Power switch
_) Outlet _) Machine socket
Machine plug _) Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch (_.
2. Insert the machine plug @ into the machine socket _).
3. Insert the power supply plug (_ into the outlet _.
4. Turn the power switch(_to turn on the power and
sewing light @.
ForYour Safety
* While in operation, always keep your eyes on the sewing area.
Do not touch any moving parts such as the thread take-up
lever, handwheet or needle.
* Always turn off the power switch and unplug from the power
supply:
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not sewing.
When Finished Sewing
* When you are finished sewing, turn alt controls to off (" O ")
position, then remove plug from outlet.
* Unplug foot control from machine.
* Lower presser foot lifter.
* Turn handwheel to lower needle bar to the lowest position.
* Place your machine out of reach of children in safe, dry
location.
Operating Instructions:
"For appliances with a polarized plug (one blade
wider than the other). To reduce the risk of electric shock,
this plug is intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
power outlet. Do not modify the plug in any way."
"Foot Controller Model YC-482J-1 or TJC-150 is used with
Sewing Machine Model 384.18024 XXX."
XXX - represents numbers 000 through 999.
\
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
13