Singer 384.18024000 Manual De Instrucciones página 70

(_ Mark for placement of buttonhole
(_ Starting point
Slider
_There shoud be no gap.
Spring holder
Difference
Draw both threads to the left under the foot.
Insert the garment under the foot, and lower the needle at the
starting point.
Then lower the automatic buttonhole foot.
* Make sure there is no gap _) between the slider (_ and the
spring holder (_.
If there is a gap @, the length of the rows wilt be different, as
shown in (_.
Sew slowly and stop the machine at the starting point when a
buttonhole is completed.
Remove the fabric and place a pin just before the bartack at
each end to prevent cutting bartacks. Cut the opening with the
buttonhole opener.
S
\
\
After a buttonhole is sewn, move the stitch to the next stitch by
turning the stitch selector in direction of (_ or _(_, then return
the stitch back to" _]" to reset for sewing the next buttonhhole.
When finished, push the buttonhole lever up as far as it will go. s
J
69