Rear Panel - Monacor PA-306 Manual De Instrucciones

230 V~/50Hz
FUSE
8 9

4.2 Rear panel

8 Mains jack for connection to a socket
(230 V/ 50 Hz) via the mains cable provided
9 Support for the mains fuse
Always replace a blown fuse by one of
the same type .
10 Speaker terminals with transparent pro-
tective cover; to connect the speakers,
fold up the cover
Examples for connection see figs . 1– 6 on
page 3
Either connect 100 V or 70 V speakers
to the terminals "70 V" or "100 V" and
"COM" (figs . 1, 2; the maximum speaker
load for the amplifier is 60 W (PA-306),
120 W (PA-312) or 240 W (PA-324), other-
wise the amplifier may be damaged
or connect a speaker or a speaker group
with a total impedance of at least 4 Ω to
the terminals "4-16Ω" and "COM" . Fig-
ures 3 to 6 show various ways to obtain
the minimum impedance . However, there
are also other possibilities .
WARNING Always fold down the
cover when operating the
amplifier . A dangerous
high voltage is present
at the terminals; you will
risk an electric shock if you
touch them .
11 Control MUTE LEVEL to adjust the level of
volume attenuation for the inputs CH 2,
CH 3 (15), CH 4 and CH 5 (17) when an
announcement is made via the input
CH 1 (2, 12)
12 Input CH 1 (combined XLR / 6 .3 mm jack,
bal .) for connection of an audio source
(either a microphone or a unit with line
signal level);
for a phantom-powered microphone,
engage the button PH . PWR (14)
The jack is connected in parallel with the
jack MIC CH 1 (2) on the front panel . For
OUTPUT MUTE
LEVEL
COM COM COM 4-16 Ω 70 V 100 V
MIN MAX BAL/UNBAL
10 11 12
the priority circuit of the input CH 1 see
item 2 .
13 Controls GAIN for the channel CH 1
Use the control to match the input sensitiv-
ity to the output level of the audio source:
When a microphone is connected, turn the
control clockwise; when an audio source
with line level is connected, turn the con-
trol anti-clockwise . If required, readjust
the control GAIN after the amplifier has
been set into operation: When the con-
trol CHANNEL 1 (3) must be turned back
very far (sound too loud or distorted) or
turned up very far (sound too low) to set
the volume desired, turn the control GAIN
anti-clockwise or clockwise accordingly .
14 Button PH . PWR to activate the 48 V phan-
tom power for the jack CH 1 (12) on the
rear panel
[The jack MIC CH 1 (2) on the front panel
is not able to supply phantom power .]
Caution! When the phantom power
has been activated, do not connect any
microphone with unbalanced output;
this microphone may be damaged .
15 Inputs CH 2 and CH 3 (6 .3 mm jack, unbal .)
to connect microphones
16 Input TEL INPUT (plug-in screw terminal)
to connect a telephone system with line
level output or another line signal source
for important announcements .
With a signal present at this input, the sig-
nals at the other inputs will be faded out .
To make connection easier, it is possible
to remove the terminal from its plug-in
connection .
17 Inputs CH 4 and CH 5 (RCA jacks) to con-
nect audio units with line output (MP3 / CD
player, radio, tape deck, etc .)
18 Line output OUTPUT (RCA jacks) for the
mixed signal to connect, for example,
an additional amplifier if more speakers
are required than the PA-306 / PA-312 /
PA-324 can handle
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
MIC/LINE INPUT MIC INPUT TEL INPUT
CH 1
PH.PWR
+ 48 V
CH 2 CH 3 G
ON
GAIN OFF
LINE MIC
13 14 15 16
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
LINE INPUT OUTPUT
CH 4 CH 5
L
R
17 18
5 Specifications
Output power
Rated power
PA-306: . . . . . . . . . 60 W
PA-312: . . . . . . . . . 120 W
PA-324: . . . . . . . . . 240 W
Music power
PA-306: . . . . . . . . . 80 W
PA-312: . . . . . . . . . 160 W
PA-324: . . . . . . . . . 340 W
THD: . . . . . . . . . . . . . . . < 0 .5 %
Outputs
Speakers (10): . . . . . . 4 – 16 Ω, 70 / 100 V
Line (18): . . . . . . . . . . 0 .775 V/ 600 Ω
Inputs
Sensitivity/ impedance; connection
MIC CH 1 (2): . . . . . . 6 mV/ 600 Ω;
CH 1 (12): . . . . . . . . . 6 – 260 mV/ 2 kΩ;
MIC CH 2, CH 3 (15): . 5 mV/ 600 Ω;
LINE CH 4, CH 5 (17): . 350 mV/ 10 kΩ; RCA
TEL INPUT (16): . . . . . 1 V/ 10 kΩ, screw
Phantom power
for MIC INPUT CH 1: . . . 48 V (⎓),
Frequency range: . . . . . 50 – 16 000 Hz
Tone controls
BASS: . . . . . . . . . . . . ±10 dB / 100 Hz
TREBLE: . . . . . . . . . . . ±10 dB / 10 kHz
S / N ratio
Mic: . . . . . . . . . . . . . 66 dB
Line: . . . . . . . . . . . . . 80 dB
Power supply: . . . . . . . . 230 V/ 50 Hz
Power consumption
PA-306: . . . . . . . . . . . 250 VA max .
PA-312: . . . . . . . . . . . 450 VA max .
PA-324: . . . . . . . . . . . 740 VA max .
Ambient temperature: . 0 – 40 °C
Dimensions (W × H × D)
PA-306, PA-312: . . . . 430 × 88 × 335 mm,
PA-324: . . . . . . . . . . . 430 × 88 × 380 mm,
Weight
PA-306: . . . . . . . . . . . 6,7 kg
PA-312: . . . . . . . . . . . 7 .8 kg
PA-324: . . . . . . . . . . . 16 .6 kg
Subject to technical modification .
6 .3 mm jack, unbal .
combined XLR / 6 .3 mm
jack, balanced
6 .3 mm jack,
unbalanced
terminals, balanced
to be activated
2 RS
2 RS
7