Automatic Power Saving Function - Teac AD-850 Manual Del Usuario

Timer-controlled playback and recording (contd.)
7
Adjust the recording level.
Failure to do so could cause the recorded sound to be distorted
or noisy .
Adjust the REC LEVEL knob so that the peak level meter never
exceeds 0 continuously .
8
Set the programmable timer to your desired start (power
on) and stop (power off) times.
When this setting is completed, the power to all components
will be switched off .
38

Automatic power saving function

ATTENTION
The automatic power saving function is only included in
European models.
The automatic power saving function is ON when this unit is shipped
new, so it will automatically enter standby if 30 minutes pass under
the conditions shown below .
Status CD
No disc , cassette tape or

connection
Stopped

Recording paused
 Automatic power saving function active
- Automatic power saving function not active
/ Not applicable
To reactivate the unit after it has entered standby automatically, press
any button on the main unit or the remote control .
o If pressing the POWER button on the main unit, you must press it
twice .
Changing the automatic power saving setting
1
Press the SOURCE button to select CD.
2
Press the CD OPEN/CLOSE (-) button to open the
disc tray.
ATTENTION
o Do not close the disc tray until the following steps are
completed .
o The disc tray will close automatically if one minute passes
without operation .
3
Press the REPEAT button for at least 5 seconds to
show the current setting ("ERP ON" or "ERP OFF").
4
Use the CD Skip (.//) buttons to change the
setting, and press the REPEAT button to confirm the
change.
5
Press the CD OPEN/CLOSE button to close the disc
tray.
USB flash drive Cassette tape
 
 
- -