RIDGID R4513 Manual Del Operador página 23

ASSEMBLY
To open the leg stand:
 Grasp the grips on the saw table and stand it upright as
shown below.
 Step on the release lever and pull the grips toward you
at the same time.
 Once the leg stand is released from the release lever,
ease the leg stand toward the floor by pushing the grips
toward the floor.
 With your hands on the grips, push the leg stand towards
the ground until the table saw is in an open position.
NOTE: The release lever will close over the center brace
locking the leg stand in an open position.
RELEASE
LEVER
GRIPS
LEG
STAND
Fig. 27
23 − English
Fig. 28
CENTER
BRACE
RELEASE
LEVER
Fig. 29