Troubleshooting - SHERCO 50 SE Manual De Propietario

50 SE-SM
What to do in an emergency?
n TROUBLESHOOTING
VERSION
Engine does not start
The engine misfires
The engine overheats and
loses power
Insufficient front braking
Insufficient rear braking
92
CAUSE
- Fuel system is clogged (fuel
line, pump or filter)
- Air filter excessively Dirty
- The current does not arrive
at the spark plug
- Engine flooded
- Spark plug electrodes not
properly gapped
- Dirty spark plug
- Exhaust partially closed
- Exhaust port obstructed
- Mixture too lean
- Ignition timing retarded
- Worn brake pads
- Presence of air or moisture
in the hydraulic system
- Worn brake pads
- Presence of air or moisture
in the hydraulic system
REMÈDE
Clean the system
Clean as shown on
☛
Clean or replace the spark
plug. If the problem persists,
contact a Sherco approved
dealer.
Open the throttle handle and
try starting by aggressively
using the kickstarter. Remove
and dry the spark plug.
Properly gap the spark plug
Clean or replace the spark
plug
Contact a Sherco Dealer
Contact a Sherco Dealer
Contact a Sherco Dealer
Contact a Sherco Dealer
Contact a Sherco Dealer
p.82