Crown Molding Angled To Table And Fence; Miter And Bevel Settings For Standard Crown Molding Cuts - Bosch GCM18V-08 Instrucciones De Funcionamiento Y Seguridad

2610051914.qxp_GCM18V-08 6/24/19 1:56 PM Page 39
▶ Crown Molding Angled to Table and
Fence
Fig. 43
Crown Molding
Angled Against
Fence
Optional
Crown Stop
Follow these instructions for cutting crown
molding angled to table and fence:
with the saw Off by conducting a simulated
cutting cycle, and observe the projected path of
the saw blade. Keep hands at least six (6) inches
away from the projected path of the saw blade.
Saw Operations
Bottom Edge
of Molding
45° Miter
Be aware of the path of the
saw blade. Make a dry run
▼ MITER AND BEVEL SETTINGS FOR STANDARD
CROWN MOLDING CUTS
(When Workpiece Angled Against Fence)
Assumptions:
Ceiling
52°
Wall
38°
38/52°
Crown Molding
38° Spring Angle
Inside
Corner
Refer to Chart
For any Crown Molding up to 6"
Note: Always place bottom
edge against fence
Inside Corner
Outside Corner
Cutting – Angled to Table and Fence
Fence
39
Ceiling
45°
45° Wall
45/45°
Crown Molding
45° Spring Angle
Outside
Corner
Miter Bevel
(Table) (Tilt)
Setting Setting
Bottom Edge
Molding Placed
Upside Down
Crown Stop
Table