Assembling And Adjustments; Assemble The Wall Mountings; Fit The Wall Mounting As Set Out Below; Mirrored Wall Brackets - Husqvarna WS220 Manual De Instrucciones

Assemble the wall mountings

3
1
5
1 The half of the wall bracket closest to the wall has
grooves for expander bolts as well as a spirit level for
horizontal mounting of the bracket.
2 The half of the wall bracket that holds the rail has a
spirit level for vertical mounting.
3 Spring weighted clamping washer. The clamping
washer locks the rail to the wall bracket, which
enables the rail to be snapped shut in the wall bracket
which facilitates mounting.
4 Locking screw for tightening the clamping washer.
5 Locking screw for angle adjustment. Normally, the two
halves should be placed in neutral position which
places the blade in a 90° angle to the concrete surface
to be cut. The position may however be adjusted for
example when cutting an uneven concrete surface.
Fit the wall mounting as set out
below:
The wall brackets may be placed using the camp and
washer on either side of the rail.
Mark the cutting line and mark the holes for the expander
bolts approximately 150 mm (5.9 inches) from the cutting
line.
The wall brackets should be placed approximately 1/2 a
rail length apart, and the distance between a wall bracket
and the end of the rail should be approximately 1/4 of a rail
length.

ASSEMBLING AND ADJUSTMENTS

2
4
• Drill the holes for the expander bolts according to the
manufacturer's instructions. Make sure to use
mounting elements adjusted to the material being cut.
The sawing equipment is accompanied by a package
containing an M10x40 expander anchor for which the
hole should be drilled with a 12 mm drill. Follow the
instructions on the expander bolt packaging.
• Hang the two wall brackets loosely in the expander
bolts, the equipment is accompanied by M10x35 bolts
and a Ø10,5x22 washer. Ensure that the bolt's head
does not rise above the rail plane.
The distance between each wall bracket and the cut line
should be 80 mm (3.15'). If the cutting line is exactly
vertical or horizontal, and the supporting surface is even,
the spirit levels on the wall brackets may be used to line
these up exactly at this early stage, after which the
expander bolts are tightened to 40 Nm. In other cases it is
necessary to wait with tightening the expander bolts until
the rail has been mounted on the wall brackets.

Mirrored wall brackets

2
1
4
In order to improve access to the locking screws for angle
adjustment (4) and/or the locking screw for the clamping
washer (5), the wall brackets can be mirrored.
• Remove the screw (4) holding together the two halves
of the wall bracket (1) and (2). Separate the two
halves.
• Move the pin (3) from one side of the wall bracket half
(2) to the other side.
• Press together the two halves again and refit the
screw (4) from the other side. In normal position, the
index line on the wall bracket half (2) should align with
the 0-line on the wall bracket half (1).
4
3
5
English
–
13