Stopping; Dismantling And Cleaning - Husqvarna WS220 Manual De Instrucciones

Stopping

• After the cutting is finished, the blade is fed out of the
wall while rotating until the pivot arm points straight
out from the wall.
• Turn off the blade rotation and the water flow.
• Move the saw to a suitable work position for
dismantling.
• Turn off the power unit by pressing the emergency
stop on the power unit.
• Make sure that the cut blocks are secured with
wedges in order to prevent them from falling out
during disassembly.
• If further cuts are to be made, the equipment should
be moved to the next cut, before moving it the power
cable should be released from the saw unit.

Dismantling and cleaning

IMPORTANT! Do not use a high pressure washer to
clean the saw.
• When the cutting is completed, the equipment should
be cleaned and reassembled on the transport trolley.
• Disconnect the power cable between the saw unit and
the power unit, assemble the guards lids on the plug
connectors. Hang the power cable on the designated
place on the transport trolley.
• Disconnect the water hoses from the saw unit and
hang these on the designated place on the transport
trolley.
• Clean the equipment using the water hose, a brush
and rag. NB! Do not use a high pressure washer or
steam cleaning equipment. After cleaning, movable
parts should be dried and greased with oil spray in
order to prevent corrosion.
• Dismantle the blade guard, clean the blade guard
thoroughly inside and out in order to prevent dirt from
drying into the guard. Hang the guard on the
designated place on the transport trolley. Remove the
blade guard guide and place it in the designated
accessory box.
• Dismantle the blade, hang it on the designated place
on the transport trolley and secure it using the outer
blade flange and the blade bolt.
• Release the saw unit from the rail by pressing down
the locking buttons and folding out the locking
handles. Carry the saw unit to the designated place on
the transport trolley and secure it with the locking
handles.
• Dismantle the rail by releasing the clamping washer
carriage bolts on the wall brackets and lifting the rail
out of the brackets. Then separate the rails by
releasing one of the ex-center bolts in the middle of
the rail, place both of the rail units on the designated
place on the transport trolley with the end stoppers
facing down. Dismantle the wall brackets and place
these in the designated accessory box.
22 – English
STARTING AND STOPPING