3-4 Handpiece Holder
Peel off cover of the Double-Faced Tape.
Fix the Handpiece holder on the flat surface.
3-5 Handpiece Cord Holder and Control Unit Holder
( Fig.4 )
Align the chase and Slide the Control Unit into the
Control Unit Holder.
Tuck the Handpiece Cord into Handpiece Cord
Holder.
Peel off the Double-Face Tape cover and put the
Control Unit Holder under the Table or Tray.
CAUTION
· Do not pull the Handpiece cord forcibly. This is
because water tube had bended forcibly that is
inside the Handpiece cord. Water may not be
out appropriately from the handpiece. ( Especially
for connection for Handpiece cord to Handpiece
cord Holder )
· You can mount Control Unit Holder on the Top
Surface and Bottom Surface.
3-6 Rubber Pad
To stop slipping the Control Unit on the table, mount
the Rubber Pad at the bottom of it.
1 ) Clean bottom of the Control Unit.
2 ) Fit the Rubber Pad appropriate place as shown on
the Fig.5.
CAUTION
Control Unit Holder is not mount to the bottom
when a Rubber Pad is attached to the bottom.
4. Mounting and Removing the Handpiece
Align the Dots on the Handpiece and the Handpiece Cord. Push
handpiece into connector.
To remove the handpiece, grip the Handpiece and plug of the
handpiece cord then pull it out stright. ( Fig. 6 )
WARNING
To avoid Electrical Shock Do not touch the handpiece
backend electrical contacts.
CAUTION
Always confirm that the handpiece is correctly seated and locked into place.
( Fig.3 )
Control Unit Holder
Chaser
Rubber
Pad
Handpiece backend
Handpiece
6
To flat surface
Double-Faced Tape
Double-Faced Tape
Handpiece
Cord Holder
Handpiece
Chaser
Cord
Dots
Handpiece Cord
Fig.3
Fig.4
Fig.5
Fig.6