Assembly; Operation - Ryobi P721 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious
injury or vision loss.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is suf-
ficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 General illumination of most work area spaces
NOTICE:
This product is designed to be powered by either a
Ryobi One+ 18V battery pack (DC mode) or by 120V
™
™
wall outlet (AC mode). Either power source can be used
by installing an approved battery pack or power cord into
the product as described in this manual.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
WARNING:
Always remove battery pack or unplug extension cord
from your product when you are assembling parts,
making adjustments, cleaning, or when not in use.
Removing battery pack or unplugging extension cord
will prevent accidental starting that could cause serious
personal injury.
INSTALLING/REMOVING POWER CORD
See Figure 2, page 9.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
 Route the power cord through the cord retainer.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source.
 Make sure the power cord is secured before beginning
operation.
6 – English