Utilitech 00761 Manual De Instrucciones página 14

EXISTING CONSTRUCTION (JOIST/ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
11. Secure the hanger bars (C):
a. Extend four hanger bars (C) to the joist.
b. Mark the joist at the keyhole slots of four hanger bars
(C).
c. Drive four long screws (AA) into joist at the top of
four keyhole marks.
d. Place four hanger bars (C) onto four long screws
(AA), then tighten four long screws (AA) securely.
Hardware Used
• Long Screw
Gjll)))
))Ill\)) Ill)) I\)))) I \I lJJ>
x4
12. Insert the existing wires from the installation location
through the punch-out hole on the housing (A).
13. Connect the wiring according to the wiring diagram.
a. Connect the black wire from the fan to the black wire from
the fan switch with two-port quick connect (GG).
b. Connect the black wire from the light to the black wire from
the light switch with two-port quick connect (GG).
c. Connect the white wire from the fan to the white wire from
the light and connect to the line in from the ceiling with
three-port quick connect (HH).
d. Connect the ground/green wire from the unit to the ground
wire in the ceiling with two-port quick connect (GG).
Swi tch Box
- B lack
~ \J\Ih ite
=
Green/(bare )
Fan
Note: For single wall switch applications, remove and cut
the clear 2 port connectors from the 2 black wires
coming from the bath fan chassis. Strip 1/2 in. of
insulation from the wire ends and connect both black
wires to the single black wire coming from the ceiling/
switch·
L------___;;,~~-------;rffi ::::::::U=T=IL=I T = E= C= H ~ . ]
Lowes .com
~
- · - .
14