Final Installation Instructions - Utilitech 00761 Manual De Instrucciones

EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
8. Strip 1/2 in. of insulation from wire ends. Grip the wire
firmly and push the stripped end of the wire into the open
port of two-port quick connect (GG) or three-port quick
connect (HH). Use only one stripped end of the wire per
port. Verify the stripped end of the wire is fully inserted to
the back of two-port quick connect (GG) or three-port
quick connect (HH).
Hardware Used
G
Two-port Quick Connect
~
x3
~
Three-port Quick
Connect~
X
1
9. Install the previously removed wire housing cover (J)
into the housing (A) and secure using the wire housing
screw (FF). Ensure all of the wiring connections are
inside of the housing (A) or under the wire housing
cover (J).
Hardware Used
• Wire Housing Screw
~
Proceed to FINAL INSTALLATION INSTRUCTIONS
below.
FINAL INSTALLATION INSTRUCTIONS
1. Insert the slot on the motor assembly (B) into the
X
1
hook of the housing (A), then install the motor assembly
(B) into the housing (A). Rotate the housing lock (I)
counterclockwise to lock the motor assembly (B) in place.
18
house
wires
•
~UTILITECH'
J
Lowes .com
\:1 - · -