TRAPP KM 300 Manual De Instrucciones página 30

Extension Cord Support
(Except MC-50/60E)
For safety and comfort, this lawn mower
is equipped with a support to direct
extension cord to the opposite of safety
lever.
The operator must unwind the extension
cord totally and proceed as follows:
Fold the extension cord and pass through
the opening of the support (1).
Then loop around hook (2), leaving a
loose fit between support and safety
lever (3).
28
1
2
3
Removing
Cutting Blade
Models MC - SL - TS - KM
Turn off and unplug lawn mower from
power source.
Using tool furnished by TRAPP (7) (except
MC 50/60E), loosen screw (6) from the
axle of the motor (8) that holds the blade
(5) and flange (4).
Replace cutting blade.
1
4
6
Replacing Cutting Blade
Remove side screws (1), and cover (2).
Using one hand firmly hold fan of the
motor (3).
With the other hand turn flange (4) until
the axle of the motor locks in place.
Proceed attaching other parts as illustrated,
and finish by attaching motor cover (2).
2
3
1
8
5
7