Monacor JTS MH-850 Manual De Instrucciones página 7

Micrófono con emisor uhf
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5 Setting the Microphone into Operation
1) Before switching on the microphone, set the re -
ceiver to an interference-free transmission channel
(see instruction manual of the receiver).
2) Then switch on the microphone: Set the sliding
switch (4) to ON. The LED status indication (3)
shows green to indicate normal operation. If it
shows red after switching on or during operation,
the inserted batteries are almost exhausted and
must be replaced.
3) To adjust the transmission channel, remove the plas-
tic cap (2). For this purpose, slightly press the
grooved latch on the side of the cap, then remove
the cap.
4) Set the microphone to the same channel adjusted
on the receiver: Turn the rotary switch CH (8) by
means of the small adjusting key supplied in such a
way that the arrow will point to the desired channel.
The 16 transmission channels are assigned to
the following transmission frequencies:
Channel
Frequency
1
790.875 MHz
2
792.625 MHz
3
794.250 MHz
4
795.625 MHz
5
797.125 MHz
6
798.875 MHz
7
801.125 MHz
8
802.250 MHz
Note: If other wireless transmission systems are
operated with this wireless system at the same
time, the radio frequencies of the individual
systems should be carefully matched to each other
to prevent interference. Examples for frequencies
for simultaneous operation of several systems can
be found in the Internet on www.jts-germany.de
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
Channel
Frequency
9
803.625 MHz
10
805.250 MHz
11
805.750 MHz
12
808.625 MHz
13
809.125 MHz
14
810.000 MHz
15
813.250 MHz
16
813.750 MHz
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
under "Informationen/Intermodulationsfreies Fre-
quenzsetup".
5) After adjusting the transmission channel, replace
the plastic cap.
6) To switch off the microphone after operation, set the
sliding switch (4) to OFF.
6 Replacement Microphone Cartridge
The microphone cartridge (1) can be replaced by the
capacitor microphone cartridge DMC-800-6 by JTS
which offers a supercardioid characteristic and a wider
frequency range (50 – 18 000 Hz).
7 Specifications
Approval No.: . . . . . . .
Type of unit: . . . . . . . . dynamic hand-held micro-
Directivity: . . . . . . . . . hypercardioid
Radio frequency
range: . . . . . . . . . . . . 790 – 814 MHz,
Audio frequency
range: . . . . . . . . . . . . 50 – 16 000 Hz
Frequency stability: . . ±0.005 %
Transmitting power: . . 10 mW (EIRP)
Ambient temperature: 0 – 40 °C
Power supply: . . . . . . two 1.5 V batteries
Dimensions: . . . . . . . . Ø 55 mm × 260 mm
Weight: . . . . . . . . . . . 250 g
Subject to technical modification.
®
0197
!
phone with PLL multifre-
quency transmitter
divided into 16 channels
(→ table, chapter 5)
of size AA (R6)
7

Publicidad

Tabla de contenido
loading

Tabla de contenido