GB
GB
•
The flue gas ducting has to be accessible for checking and cleaning. It is necessary to provide possibility of sweeping of the entire length
of the chimney, and the chimney door has to be easily
•
Check attentively whether the chimney is tight and that no leakage of flue gases occurs around the chimney door and connection of the
flue gas ducts.
•
Flue gases are to be drawn through the flue gas ducting with the diameter of 150 mm connected to the neck of the flue gas ducting of the
stove, which is placed on the upper (rear) part of the stove.
4.5
Connection of central air supply
Connection of central air supply has to be realized in air-tight buildings, where the content of oxygen in the room
heated by the pellet stove can be decreased.
•
Connect the hose to the suction neck for air on the rear wall (Ø 50 mm).
•
The entrance of the air supply line has to be placed in outdoor space or in sufficiently vented room of the building.
•
At installation of the stove in a building with controlled ventilation of habitable premises, the entrance of air supply mustn't be placed in a
room, which is connected to the associated ventilation system.
•
In order to ensure sufficient air supply, the supply line mustn't by longer than 3 m and mustn't have too much bends. The minimum
diameter of the supply line is 50 mm.
•
If the supply line enters into the outdoor space, it has to be bent by 90° in the down direction or has to be ended in the dead air region.
5
Commissioning
Wrong operation and insufficient combustion of fuel brings to a damage of the product.
The control of the AGURO pellet stove is very easy. Control elements of the pellet stove are displayed in Fig. 6.
Fig. №. 5
5.1
Opening of the pellet stove door
The stove has two doors. The cast-iron door separates the heating chamber from other environment, and the glassed one is decorative and
completes the pellet stove design.
Be particular about sealing surfaces of the inner frame of the cast-iron door to ensure their easiest closing. The cast-iron door can be opened
with help of a handle; the decorative door can be opened by means of a clip and a magnet (they are a part of delivery). Observe cleanness of
the both doors.
The both doors always during stove operation have to be closed, otherwise the stove wouldn't work correctly and can be damaged!
If necessary, always open the cast-iron door slowly and carefully, in order to avoid sudden change of pressure in the heating chamber and
escape of smoke into the room.
5.2
Safety instructions
•
At handling and unpacking, be careful and observe safety instructions!
•
In case that there is a danger of occurrence of flammable gases for the temporary period in the room with an installed stove (for
example, during gluing of linoleum, at painting work, etc.), the pellet stove has to be put out of operation even before
occurrence of this danger!
•
During burning of the surface painting of the stove at the first firing-up, it is necessary to ventilate all the time and bring
sufficient quantity of fresh air into the room!
•
At operation it is necessary to provide sufficient supply of combustion air and safety withdrawal of flue gases!
•
The both doors have to be always closed!
•
The pellet stove may only be operated by a capable adult person!
•
Ensure that children, persons with mental disabilities and domestic animals cannot get to the space of the furnace itself or very
hot parts during operation of the stove (doors, glass, side covers, the furnace cover, etc.) – danger of burning and possible life
danger!
•
For the entire period of operation, fire in the stove has to be regularly checked!
•
In case of simultaneous operation of other heating device in the same room, it is necessary to ensure sufficient ventilation!
accessible.
Navigation in menu „UP", increase the value
Navigation in menu „DOWN", decrease the value
Button in menu „EXIT"
Button in menu „CONFIRM"
Button in menu „ON/OFF"
Button „WARNING"
84