GBC HeatSeal 535 Turbo Manual De Instrucciones página 7

GBC5137 HeatSeal H535 Manual EU
Carrier Function
This function should only be used when using a carrier (folded
cardboard that protects the pouches).
Tip: It is preferable to use a carrier (item number: EK04000 for
A4, EK03000 for A3) in case you laminate non-standard
document sizes.
1 Press function button and the Carrier icon shows up to
indicate carrier laminating operation.
2 The machine will automatically begin warming up, cooling down,
or adjusting the speed for carrier operation if necessary.
3 Similar to carrierless laminating, there are 15 Preset modes of
carrier laminating. Expect the carrier icon and different preset
setting values, all the other functions remain the same as the
carrierless operation.
4 To go back to the carrierless operation, press
Specifications
Electrical
Machine Dimensions (W x L x H)
Machine Weight
Maximum Pouch Width
Maximum Pouch Thickness
Maximum Thru-put Thickness
Operating Speed
Warm-Up Time
Guarantee
Operation of this machine is guaranteed for two years from date of
purchase, subject to normal use. Within the guarantee period, GBC will
at its own discretion either repair or replace the defective machine free
of charge. Defects due to misuse or use for inappropriate purposes are
not covered under the guarantee. Proof of date of purchase will be
Register this product online at www.gbceurope.com
20/12/05
again.
GBC HeatSeal 535
220V-240V / 50Hz / 5 Amps / 1140W
594 x 282 x 152mm
9.65 Kg
A3
2x250 mic (Total 500)
2.5mm
1000 mm/min
5 minutes
17:15 Page 7
Reverse Function
for clearing jams or removing pouches
during laminating
Press and hold down button momentarily, the rollers will
1
reverse and document will return from the front entry. The
Reverse icon will show when the
2 When is released the machine will continue in previously
selected forward run position.
Auto Shut Off
When the machine is not operated for an hour, the machine will
1
automatically shut off itself to protect the machine and save the
electricity.
2 5 minutes before auto shut off, the machine starts beeping
intermittently and the LCD panel starts blinking until the machine
is fully shut down.
To turn on the machine after auto shot off, the power switch is
3
required to switch back to "OFF" and switched to "ON" again to
restart the machine.
4 Please note that the machine will auto shut off in case of motor
failure.
required. Repairs or alterations made by persons not authorised by GBC
will invalidate the guarantee. It is our aim to ensure that our products
perform to the specifications stated. This guarantee does not affect the
legal rights which consumers have under applicable national legislation
governing the sale of goods.
button is pressed.
7