Internal Memory; Transmitting Stored Data - NSK Surgic Pro Manual Del Usuario

NOTICE
A BMP file can only be created only when Gear Ratio is 20 1 and the number of rotations is 50min
*BMP File
Time Torque
Date Rotation Speed
Torque
CAUTION
• Total recording time is about 100 minutes.
• Do not insert a USB flash drive during operation. Only insert after operations are completed in order to store data.
• Do not use data stored in USB flash drive for diagnostic purposes.
• Do not use a USB flash drive other than USB 2.0. (To 32GB verification being complated)
• Do not remove USB flash drive while the LED lamp is on or blinking.
• The LED lamp and their meanings are given below:
lamp on = internal memory is copying data, blinking = USB flash drive is storing data.
• This device is not guaranteed to work with all USB flash drive. It may not work with USB flash drive with security
functions or those which use a great deal of electricity.
• Do not turn the device on or off with the USB flash drive inserted.
• Be careful to insert the USB flash drive in the correct direction.
• When a USB flash drive is not connected, close the cover of the connector.
• If power is turned off, the internal memory will be erased. Turn off power after storing data on USB flash drive.

6-5-1 Internal memory

After power is turned on and the motor begins to rotate, memorizing will begin automatically (A USB flash drive need
not be connected).

6-5-2 Transmitting stored data

1) Insert a USB flash drive. (When correctly recognized, the USB flash drive mark will appear on the LCD).
2) Push the USB REC key to copy stored data onto the USB flash drive (During the control unit copying the data.
LED lamp blink).
NOTICE
• Distinguish rotating direction and torque that has been set using line types.
• While in operation (memorizing), the LED lamp will light up. About 10 seconds after operation stops, the LED lamp
will turn off and memorizing will stop temporarily (The time counter will also stop temporarily).
6-5-3 Resetting
Press the USB REC key for at least 2 seconds. The amount of remaining recording time will be reset after the
beep goes off (Initialized time: 100 min).
Irrigation Volume
Gear Ratio Program Number
Set torque index
Time
15
-1
or less.