GPO PR100 Manual Del Usuario página 12

TURNTABLE
INSTALL THE TURNTABLE
1. P ut the turntable on a flat surface
2. Put the turntable with the center axis in straight and install the
turntable onto the plate base.
3. Pull the rubber band around the back plate through the round
opening with a finger wrap and loop it around the motor pulley
- Do not let the rubber twisted
- Turn left and right the turntable several times to check the rubber
runs smoothly and well installed.
4. Put the rubber mat onto the turntable base.
PREPARING THE TURNTABLE PLAYER
To balance the tone arm and adjust the stylus pressure
1. Open the turntable cover
2. Set the anti-skating dial to zero
3 Release the tone arm holder
4 Lift the tone arm lift lever and turn the tone arm to the left gently.
5 Turn & adjust the counterweight to make the tone arm level.
Remove the stylus cap before adjustment & be careful not to let the
stylus touch the unit
6 Return the tone arm to the original position and lock it.
7 Turn & adjust the stylus pressure ring to let the center line align
with 0. (Do not let the counterweight turn)
12
GPO PR100_user_Manual EU - Oct 2017.indd 12 26/10/2017 10:06