Brush Replacement - CMT ORANGE TOOLS CMT7E Instrucciones De Uso Y Seguridad

TABLE WINDER
1. Mount the router securely into your router table as
detailed in your router table instructions. Turn the
table (with router fitted) upside down.
2. With a marker pen trace the scallop in the
base of the router onto the underneath of your
router table. Complete the tracing to form a circle
approximately 12.7mm (1/2") diameter.
3. Remove the router and drill a pilot hole through
the centre of your circle. Using a 12.7mm (1/2")
bit drill your final access hole.
WARNING:
File off any rough burrs using a round file.
4. Refit the router and turn the router table right way
up.
5. Fit the table winder handle (N) through the hole
in the tabletop and push it onto the routers
winder mechanism.
WARNING: If necessary extend your hole using a round file.
6. Release the plunge lock lever and use the winder handle to set your cut depth.
CALIBRATION MARKS:
Each line on the winder wheel represents 0.2mm (1/128") cut depth increments. A full 360 degree
turn is equal to a 2mm (3/32") depth adjustment.
7. Re-lock the plunge lock lever and commence your work.

BRUSH REPLACEMENT

The carbon brushes (u) are a consumable item which
should be inspected periodically and replaced when
worn.
1. With the router disconnected from power, unscrew
the Brush Caps (v) located on the front and rear of
the motor.
2. Remove the brushes by pulling carefully on the pro-
truding springs. Fig. 32.
3. If either of the brushes (u) is worn to less than
6mm (1/4") long, they must both be replaced using
genuine CMT replacement brushes - available from
Authorised CMT Repair Centres.
CMT will not be responsible for any damage or injury
caused by unauthorised repair of the router or by
mishandling of the tool.
www.cmtutensili.com
Fig. 28
Fig. 30
v
EN
Fig. 29
Fig. 31
u
Fig. 32
13