FEATURES
• Water resistant
• LCD display with indication of indoor temperature (° C)
• Easy to install with four strong suction cups
• Modern design with an elegant aluminum frame
START-Up/poWER SUppLy
1. Turn the housing cover (10) with a little force, coun-
ter-clockwise and detach it.
2 Insert a 1.5V battery into the battery compartment (6) AA/
LR6. Pay attention to the correct polar direction (+ / - ) of the
battery as indicated inside the battery compartment.
SETTING THE TImE
1. After inserting the battery, the movement works (hands
move).
2. Turn the dial (8) to set the correct time.
3. Put the front cover (10) back on and tighten it with a little
force, clockwise.
TEmpERATURE DISpLAy
After inserting the battery, the interior temperature is displayed
on the LCD display (9). The temperature range is between 0°C
~ +50°C.
moUNTING/poSITIoNING oF THE CLoCK
There are 3 ways to mount this clock on the wall or on a flat
surface:
8
1. Open the housing cover (10) and remove the pedestal
stand (3). Insert it into the receptacle for the stand (7) and
position the clock on a flat surface (e.g. bathroom cabinet).
2. Hang the clock using a screw or nail (not included) onto the
desired and suitable wall (2).
3. Slightly moisten the suction cups (4) and press the clock
with the suction cups against a flat wall surface.
CAUTIoN:
Always make sure to mount or stand the clock securely.
Dropping the unit may cause serious damage, for which the
manufacturer takes no responsibility! The suction cups must
be placed on a perfectly flat, clean and dry surface. Moisture
favours slipping!
NoTES oN CLEANING
Before cleaning the device, disconnect it from the power sup-
ply (remove batteries).
Only use a dry cloth to clean the exterior of the device. To
avoid damaging the electronics, do not use any cleaning fluid.
DISpoSAL
Dispose of the packaging materials properly, according
to their type, such as paper or cardboard. Contact your
local waste-disposal service or environmental authority for in-
formation on the proper disposal.