Assembling Dust Collection System - Bosch CM12SD Instrucciones De Funcionamiento

Tabla de contenido

Idiomas disponibles

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 13

WARNING

source

before

adjustments or repairs.

Attaching the Dust Bag

To attach the dust bag, squeeze the two red tabs

together and slide the dust bag into the dust port rib

(see figure 4).

Using and Cleaning the Dust Bag

Using Dust Bag – Attach the clean bag to the dust

port.

Cleaning Dust Bag – After the dust bag is 2/3 to 3/4

full, remove it from the saw. Bring the bag to a proper

container and pull open the zipper located on the

bottom of the bag. Hold the bag by the coupler end

and shake it vigorously until all the dust and debris

fall from it. Close zipper and reattach the bag.

NOTE: Clean the bag at the end of the cutting

session and before transporting or storing the saw.

WARNING

fine particle form may be explosive. Do not throw

sawdust

combustion, in time, may result from the mixture

of oil or water with dust particles.

Attaching a Vacuum Cleaner

The dust chute has an exit port which will accept a

standard 35mm diameter vacuum fitting or a 1-1/4"

tube diameter. The 35mm diameter fitting is the

standard size used on the Bosch Vacuum Cleaners.

For larger vacuum tube sizes, use an adaptor.

Attaching to Vacuum – Insert the vacuum fitting or

tube into the exit port as far as it will go, (figure 5).

Check to see that the vacuum hose is free from the

mechanism and cutting path before plugging saw into

power source.

Rubber Deflector

When slide cutting extra-tall materials (3-1/2" high),

the rubber deflector (figure 6) will contact and flex

over these materials. It will also contact and flex

when the saw is pulled back before the cut. It will

return to its original shape after the cut.

Assembly