NOCO Genius BOOST PRO GB150 Guia Del Usuario página 7

Error
Error LED
Blinking Red
w/Cables Connected
Properly
Boost Light Does
Not Come On
w/Cables Connected
Properly
Charging the GB150.
12V Fast Charge (60W):
Connect the 12V Cable to the "12V IN" port on the
GB150, and the other end to the Male 12 Plug. Plug
into a powered 12V AUX Plug (Cigarette Lighter Port.)
USB Charging (Up to 10W):
Connect the GB150 using the included USB Charge
Cable to the USB IN port and a powered USB port, like
an AC adapter, car charger, laptop and more. The USB
IN port is rated at 2.1 Amps to ensure safe and efficient
charging of the internal lithium battery.
Due to FCC regulations, we do not recommend
charging and discharging the unit at the same time.
Charging Times.
The time to recharge a GB150 will differ based on the
discharge level and the power source used. Actual
results may vary due to battery conditions.
USB Charger Rating 12V Fast Charge
.5A
Time
45hr
Reason/Solution
The internal battery is too
hot/
Allow the unit to cool.
Bring the unit into cooler
environment.
Connected battery is below
2-volts/
Remove all loads, and
try again, or use Manual
Override Mode.
1A 2A
22hr 11hr
5A @ 12V (60W)
2-3hr