NOCO Genius BOOST PRO GB150 Guia Del Usuario página 8

Charging Your USB Devices.
You can recharge virtually any USB device, like a
smartphone. Connect the included USB Charge Cable to
the USB OUT port and connect to your USB device.
The number of times you can recharge a USB device will
vary between devices. For recharge times, contact your
device manufacturer.
Powering Your 12V Devices.
Connect the 12V Cable to the "12V OUT" port on the
GB150, and the other end to the Female 12V Plug (12V
AUX/Cigarette Lighter Port.) Plug-in any standard 12V
device (Up to 15A) with a 12V plug and turn the GB150
"On" to start powering your device.
LED Flashlight.
The GB150 has an integrated ultra-bright LED flashlight. It
has seven (7) light modes that effect its performance and
longevity: 100%, 50%, 10%, SOS, Blink, Strobe, and Off.
To turn the flashlight "On" and "Off", use the Power button
with the light bulb icon. Press once to turn the flashlight
"On" at 100% luminosity, again for 50% luminosity (within
3 seconds), again for 10% luminosity (within 3 seconds),
again for SOS (within 3 seconds), again for Blink (within 3
seconds), again for Strobe (within 3 seconds) and again
for "Off". If a light mode is not selected within 3 seconds,
it will remain "On" in the current light mode, and the next
selection will turn the flashlight "Off".
Depending on the mode selection, the GB150 will have
various levels of output and runtime. Selecting a lower
power level when using the GB150 for extended periods of
time will prolong battery life.
Modes:
100% > 50% > 10% > SOS > Blink > Strobe > Off