Preparing To Use The Booster; Booster Location; Installation Instructions; Features - Schumacher Electric DSR104 Manual Del Usuario

Do not expose a booster to fire or excessive temperature. Exposure to fire or temperature above 265°F
2.10
(130°C) may cause explosion.
Have servicing performed by a qualified repair person using only identical replacement parts. This will
2.11
ensure that the safety of the product is maintained.
Attach output cables to a battery and chassis as indicated below. Never allow the output clamps to touch
2.12
one another.
3.

PREPARING TO USE THE BOOSTER

IMPORTANT: AFTER PURCHASE, CHARGE YOUR BOOSTER FOR 24 HOURS, BEFORE USE.
WARNING! RISK OF CONTACT WITH BATTERY ACID. BATTERY ACID IS A HIGHLY CORROSIVE
SULFURIC ACID.
Be sure the area around the battery is well ventilated while the booster is being used.
3.1
Clean the battery terminals before using the booster. During cleaning, keep airborne corrosion from
3.2
coming into contact with your eyes, nose and mouth. Use baking soda and water to neutralize the
battery acid and help eliminate airborne corrosion. Do not touch your eyes, nose or mouth.
Determine the voltage of the battery by referring to the vehicle owner's manual and make sure that the
3.3
output voltage of the booster is correct.
Make sure that the booster cable clips make tight connections.
3.4
4.

BOOSTER LOCATION

WARNING! RISK OF EXPLOSION AND CONTACT WITH BATTERY ACID.
Locate the booster as far away from the battery as the DC cables permit.
4.1
Never place the booster directly above the battery being jumped; gases from the battery will corrode and
4.2
damage the booster.
Do not operate the booster in a closed-in area or restrict the ventilation in any way.
4.3
5.

INSTALLATION INSTRUCTIONS

Remove all cord wraps and uncoil the cables prior to using the charger and booster.
5.1
After purchase, charge your booster for 24 hours, before use.
5.2
6.

FEATURES

7
6
5
4
3
2
1
12
8
9
18
10
17
11
1. Output voltage selector
2. Output voltage connectors
3. Voltage selection LEDs
4. Spare fuse
(on side; not shown)
5. Charging port
6. 500A fuse
7. Alarm
8. Voltmeter
9. Voltmeter button
10. Battery clamps
• 6 •
13
14
19
15
16
11. Auxiliary cable port
(on side; not shown)
12. Charger
13. Power LED
14. Start/Stop button
15. Clamps Reversed LED
16. Bad Battery LED
17. Charging LED
18. Charged/Maintaining LED
19. Charger plug