Remote Controller - Mitsubishi Electric MSZ-EF18VGW Manual De Instrucciones

● OPERATING INSTRUCTIONS ●
P
REPARATION BEFORE OPERATION

Remote controller

Battery replacement indicator
Operation
display section
(Backlight
display*)
Temperature
buttons
EN
Operation
select button
ECONO
COOL button
i-save button
CLOCK button
* The backlight turns on when using the remote controller.
The backlight goes off if the remote controller is not used for a while.
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If 2 or more indoor units are installed in proximity to one another, an indoor unit
that is not intended to be operated may respond to the remote controller.
TIME, TIMER set button
Increase time Decrease time
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
Press (Increase) and
of timer.
WEEKLY TIMER set buttons
Press to enter the weekly timer setting mode.
Press and
Press , , and
perature.
Press to complete and transmit the weekly timer setting.
Press to turn the weekly timer ON. (
Press again to turn the weekly timer OFF. (
out.)
EN-4
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit
when the signal is
received.
OFF/ON
(stop/operate)
button
FAN speed control
button
VANE control button
TIME, TIMER set
buttons
Increase time
Decrease time
WEEKLY TIMER
set buttons
RESET button
Lid
Slide the lid down
to open the remote
controller. Slide it down
further to get to the
weekly timer buttons.
(Decrease) to set the time
to select setting day and number.
to set ON/OFF, time, and tem-
lights.)
OFF/ON (stop/operate) button
Operation select button
(AUTO)
Temperature buttons
Each press raises or lowers the temperature by 1°C.
FAN speed control button
(AUTO)
Up-down airfl ow control button
(AUTO)
Left-right airfl ow direction
Move the vertical vane manually before starting operation.
i-save button
A simplifi ed set back function enables to recall the preferred
(preset) setting with a single push of the
the button again and you can go back to the previous set-
ting in an instance.
ECONO COOL button
The set temperature and the airfl ow direction are automati-
cally changed by the microprocessor.
goes
(COOL) (DRY) (HEAT)
(Silent) (Low) (Med.) (High) (Super High)
(1) (2) (3) (4)
(FAN)
(5) (SWING)
button. Press