NSK Varios 370 Operación Manual página 8

Fix the Handpiece holder on the flat surface.
•
Remove any oil and humidity on the surface before using the Double-Face Tape.
•
CAUTION
3-5 Handpiece Cord Holder and Control Unit Holder (Fig.4)
Align the chaser and slide the Control Unit into the Control Unit Holder.
Tuck the Handpiece Cord into Handpiece Cord Holder.
Peel off the Double-Face Tape cover and put
the Control Unit Holder under the Table or Tray.
Do not pull the Handpiece cord
•
forcibly as the water tube is inside
CAUTION
the Handpiece cord. Excessive
pressure on the cord may cause
problems with water distribution.
You can mount Control Unit Holder
•
on the Top Surface and Bottom
Surface.
3-6 Rubber Pad
To stop slipping the Control Unit on the table,
mount the Rubber Pad at the bottom of it.
1) Clean bottom of the Control Unit.
2) F it the Rubber Pad appropriate place as
shown on the Fig.5.
Control Unit Holder cannot be
•
mounted to the bottom when
CAUTION
Rubber Pads are attached to the
bottom.
4 Mounting and Removing the Handpiece
Align the Dots on the Handpiece and the Handpiece
Cord. Push handpiece into connector.
To remove the handpiece, grip the Handpiece and plug
of the handpiece cord then pull it out straight. (Fig. 6)
To avoid electrical shock do not
•
touch the handpiece backend
WARNING
electrical contacts.
Always confirm that the handpiece is correctly seated and locked into place.
•
Do not use a Handpiece other than that supplied with this device.
•
CAUTION
Control Unit Holder
Chaser
Chaser
Rubber
Pad
Handpiece backend
Handpiece
7
Double-Face Tape
Handpiece
Cord Holder
Handpiece
Cord
Fig.4
Fig.5
Dots
Handpiece Cord
Fig.6